The RX and upgrade firmware of the RX via visit 10.0.0.1 from the web browser(password: expresslrs)ģ-1/ Then set the corresponding serial port and receiver protocol to ensure the normal output of each channel of the receiver. – Insert the 2.4G ELRS TX to Radio transmitter, and choose External RF mode to CRSF protocol, then you can find ELRS menu from the Radio systems(Need to copy the ELRS.LUA file to the SD-Card tools first), Enter into ELRS and press, the LEDontheRX module will getting to be solid if bind successfully.ĮL24E/EL24P RX: LED solid means bind successful or Connection established LEDdouble-flash means in bind mode LED flash slowly means no signal connection fromthe TX module LED flash fast means in WIFI hotspot mode, you can connect the WIFI of When the RX is poweredonfor the third time, the LED light will start to double flash, which means that the RX enters the binding mode – Supply power to the EL24E/EL24P rx, wait until the LED on the RX is off, immediately turn off the power, and then repeat again the above steps. When the USB is connected, the green light of the receiver flashes, and then bind according to the picture operation. Tip: Image transmission control can only be controlled by IRC 3/ Receiver bindingġ / Open Remote Control D8 Protocol Binding ModeĢ / FC power-on or connected USB, click the BIND button
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |